Brooch with Swarovski® Crystals, Silver-Plated Metal Focal and Feathers



STEP 1


Lower an roughly 50mm spherical part of Lacy’s Stiff Stuff™ and leather-based scrap.


STEP 2

Apply a beneficiant quantity of E6000® Jewellery and Craft adhesive to at least one aspect of the material. Organize the quill finish of a number of goose and turkey feathers in a fan-like sample alongside the highest fringe of the material, as desired. Apply a further layer of E6000 over the quills, if wanted, to safe.

Press one 47mm fancy flower focal into the middle of the Lacy’s Stiff Stuff masking the quills. Enable to dry based on producer’s directions.


STEP three

Lower one 6-foot size of white Nymo® thread. Thread a beading needle virtually doubling the thread (to make it simpler to work with) however leaving a tail so you’re working with just one thread. Knot the tip of the working thread.

Tip: It could be obligatory to chop different lengths of thread later within the design.


STEP four

Move the needle via the Lacy’s Stiff Stuff, from again to entrance, exiting via one of many filigree areas towards the middle of the flower focal. String one luster crystal seed bead then go down via the material. Pull the thread tight securing the bead in place. Repeat to sew a seed bead over every of the filigree areas across the middle of the focal.

Move the needle up via the material exiting one of many filigree areas simply exterior the earlier seed bead row. String sufficient seed beads to fill the open space then go down via the material. Repeat to sew seed beads over every of the filigree areas on this row. Repeat to sew seed beads within the row across the earlier then trim extra thread.


STEP 5

Trim the Lacy’s Stiff Stuff near the sting of the filigree flower, leaving the sting behind the feathers as is. Apply a small quantity of E6000 the flat bar on the pin again then affix it to the middle of the again aspect of the Lacy’s Stiff Stuff and permit to dry.

Place two marks on one aspect of the part leather-based scrap, roughly 1 inch aside, the width of the pin again. Use scissors to create holes at these factors. Apply E-6000 to the again of the Lacy’s Stiff Stuff. Press the piece of leather-based scrap onto the material so the ends of the pin exit the lower holes. Trim the leather-based to match the sting of the Lacy’s Stiff Stuff then enable to dry.


STEP 6

Lower a brand new size of thread then thread a needle and knot the tip of the working thread. Move the needle between the 2 layers of material and up via the Lacy’s Stiff Stuff, near the sting of the focal, concealing the knot.

String two seed beads then go the needle down via the sting of each layers of material, roughly 2mm from the earlier sew. Move up via the material layers and the second seed bead.

String one seed bead, go down via the sting of the material layers roughly 1mm from the earlier bead then up via the earlier seed bead. Repeat to create a brick sew across the whole fringe of the material.


STEP 7

Combine Devcon® 5-Minute® Epoxy based on producer’s directions.

Apply adhesive to the middle of the filigree focal then press one crystal clear 7mm flat again into the adhesive.

Repeat to affix a row of sunshine Colorado topaz 2.5mm flat backs to the focal across the fringe of the clear flat again. Proceed to affix a row of emerald 2.5mm flat backs to the focal across the earlier row of flat backs.


STEP eight


Proceed to affix one tanzanite 2.5mm flat again within the middle of the units of seed beads, towards the sting of 1 filigree “petal” of the flower. Affix one tanzanite 2.5mm flat again simply above the earlier emerald flat again alongside one fringe of the petal then affix a second tanzanite flat again simply above it. Repeat to affix tanzanite flat backs to every petal and alongside every edge.


STEP 9


Apply adhesive alongside the pointed edge of 1 petal on the filigree focal then press one golden shadow 7mm coronary heart flat again into the adhesive. Repeat to affix a coronary heart flat again to the purpose on every petal. Enable the focal to dry utterly.

: : : Extra Assets : : :


The items featured within the Gallery of Designs are copyrighted designs and are supplied for inspiration solely. We
encourage you to substitute completely different colours, merchandise and methods to make the design your individual.


Have a query concerning this design thought? E mail Customer Service.



Source link

Comments

comments